RPI2v2 Mounting Information
Your RPI2v2 comes complete with two spacer sets to allow you to mount it onto your Raspberry Pi.
If you are fitting it to a Raspberry Pi Zero you can choose which two corners to fit the spacers to but we would recommend the two at the bottom edge. If you are mounting it to any other Raspberry Pi you will have to use the holes adjacent to the GPIO connector as the bottom ones won't line up.
To mount the RPI2v2 first insert the M2.5x6mm screws from the underside of the Raspberry Pi with a washer on each and then on the top side of the Raspberry Pi place on each a washer and then screw on the M2.5x12mm spacer provided. Onto the top of each spacer then place two washers. Now carefully push your RPI2v2 onto your Raspberry Pi. You should then have left a washer and nut to put on top of each mount.
Do not overtighten these spacers, they can normally be done up by hand without the need for any tools but if you do decide to use tools then be gentle as they are easily damaged.
If you are fitting it to a Raspberry Pi Zero you can choose which two corners to fit the spacers to but we would recommend the two at the bottom edge. If you are mounting it to any other Raspberry Pi you will have to use the holes adjacent to the GPIO connector as the bottom ones won't line up.
To mount the RPI2v2 first insert the M2.5x6mm screws from the underside of the Raspberry Pi with a washer on each and then on the top side of the Raspberry Pi place on each a washer and then screw on the M2.5x12mm spacer provided. Onto the top of each spacer then place two washers. Now carefully push your RPI2v2 onto your Raspberry Pi. You should then have left a washer and nut to put on top of each mount.
Do not overtighten these spacers, they can normally be done up by hand without the need for any tools but if you do decide to use tools then be gentle as they are easily damaged.
